AMT Electronics presents the new device – AMT U-2 Pangaea Ultima Brain Frame.
It's In Stock & Ready to Ship!
AMT Electronics presents the new device – AMT U-2 Pangaea Ultima Brain Frame.
The device is a hardware platform on the basis of which various guitar effects can be implemented in software. Changing the functionality of the device is carried out by changing the “firmware” of the device. This device complements the AMT Bricks series of devices. The AMT Bricks series includes various devices (preamps, effect pedals, noise suppressors, cabinet simulators, device controllers, pedalboards, etc.).
Uniting the AMT Bricks series factor is their design and functional compatibility.
Most of the devices of the series can be used both independently and together.
The main firmware that comes with the device by default.
A feature is an analog-digital preamp section with three channels: clean, low & high gain.
The firmware that turns “Ultima” into an effects processor is designed for the case when your Pedalboard, which already has preamp/distortion pedals, requires expanding the sound palette due to various modulation effects.
The firmware that turns the device into a powerful stereo IR impulse responses cabinet emulator.
Multifunctional STEREO IN/OUT Delay effect.
Multifunctional STEREO IN/OUT Reverb with the following types:
The firmware that turns the Ultima U-2 device to the PRE / POST effect processor.
PRE section:
POST section:
IN L, IN R – Inputs of the Left and Right channels:
– input impedance 470 kОм
– rated input voltage of audio signal 0.316Vrms (-10dBV)
– maximum sinusoidal voltage 2.5V (+8dBV)
AUX IN
– Input impedance 2kOhm
– maximum sinusoidal voltage 0.85V (-1.4dBV)
OUT L, OUT_R – Outputs of the Left and Right channels:
– output impedance 1,5kOhm (unbalanced output)
– maximum sinusoidal voltage 2,6V (unbalanced output)
– phantom power protection – present
PHONES – Output to headphones:
– minimum headphone impedance 32 Ohm
– maximum output sinusoidal voltage (no load) 2,6V (8dBV)
– output impedance 12 Ohm
POWER
– Voltage DC 12V
– Current consumption Approx. 300mA
CHARACTERISTICS OF IR FILES
– Type: WAV, IR A/D – D/A converters 24 bit
– Sampling frequency: 48 kHz
– IR length: 1024 samples (21.3 msec)
– S/N: 115dB.
– Latency: 1.2 ms / 0.0012 s
– Codec: AD\DA AK4621
DIMENSION (HxWxD) 47mm x 55mm x 95mm
WEIGHT 270 g (without package)