RADIAL Bassbone V2 Bass Guitar Preamp and DI Box w/Power Supply Open Box Mint

Simply stated, the Bassbone V2 is a bass command center. Connect any two basses and seamlessly toggle between them using a footswitch. Each channel has a separate level control to balance the two instruments and is augmented with a unique EQ that enables you to adjust the tone to match your bass amp. In fact, the passive-interactive EQ is so powerful, you can toggle between channels to emulate switching from a P-Bass to a Rickey using the same bass! A special PZB booster adds yet another dimension - allowing you to connect a piezo, such as used on an upright bass when doubling.

With the Bassbone V2, you get even more: A boost footswitch can be used to either engage a power booster for solos or can be assigned as a mute switch for quiet on-stage tuning. A third footswitch lets you activate the effects loop which is equipped with a wet-dry control to retain the tone of the original instrument and then mix-in as much of the effect as you like. The effects can be assigned to either channel or both. Once processed, you can send your sound to a stage amp, tuner and to the PA system using the built-in Radial DI box.

The Bassbone V2 is a power-packed bass preamp that combines on-stage efficiency, amazing tonal control and superb audio performance in a compact box. This makes it the ideal front end for both live and studio recording. Comes equipped with 15VDC power supply.

Features

• Two-channel bass preamp for 1 or 2 basses
• Built-in Radial DI with low-Z balanced out for the PA
• Combination power booster, effects loop and mute
• Powerful EQ and level controls for each bass

Applications (reference photos)
Using the Bassbone V2 with two bases
The Bassbone V2 is designed to let you switch between any two basses. Use channel-1 and your amp's EQ to set you primary tone. Use channel-2's ultra powerful EQ to compensate so that each instrument sounds its best.

Switching between upright and electric
The Bassbone V2's high performance preamp is well suited for all instruments including upright bass. This lets you toggle between electric and acoustic and optimize the tone going to your stage amp and the PA system. Add effects pedals using the built-in effects loop.

Using the Bassbone V2 with one bass
The Bassbone V2 is the ultimate front end for any bass. Channel-1 can be set flat or augmented with two modern presets. Channel-2's 3 band EQ is so powerful that it can turn your P-bass into a Rickenbacker!