The M Series has become the accepted standard for affordable, reliable reference and measurement microphones that are accurate in the time domain and frequency response. They are remarkably stable with respect to temperature and atmospheric conditions and are optimized for clean, very fast impulse performance providing accurate wideband response with virtually no handling noise.
- Cost effective measurement microphone
- Ideally suited for acoustical measurements including loudspeaker design and quality control, sound system setup and troubleshooting, room acoustics, or any application where an accurate free-field measurement microphone is required
- Omnidirectional polar pattern
- Flat frequency response, fast impulse response and exceptional polar characteristics
- Used by SMAARTﾙ, MLSSAﾙ, Spectrafooﾙ, TEFﾙ and RTA in addition to acoustic measurement systems manufactured by dbx, DEQX and others
- Meets or exceeds ANSI Type 1 and applicable IEC 61094 requirements
- Requires 48V Phantom Power
- Each M Series microphone is delivered with its own calibration chart providing its individually measured open-circuit sensitivity and the frequency response curve
- Transducer: Condenser
- Polar Pattern: Omnidirectional
- Frequency Response: +/- 1dB 9Hz to 27kHz, +1 / -3dB 5Hz to 30kHz
- Dynamic Range (Typical): Not specified by manufacturer
- Signal-to-Noise Ratio: 27dB SPL Equivalent (A weighted)
- Maximum Input Sound Level: 150dB SPL
- Power Requirements: +48V Phantom, 10mA
- Output Impedance: 600 ohms between pin 2 and pin 3
- Output Connectors: XLR intended to drive a balanced transformerless input Pin2+
- Pad: No
- Low Frequency Roll-Off: No
- Dimensions: 9 x 0.860″ (229 x 22mm)(Length x Diameter)
- Weight: 0.5 lb (225 g)
